Hitachi YUTAKI Series - Setting-Up

139
System MMI Pack (Room unit and RF receiver)
SMGB0066 rev.0 - 12/2009
Controller pack
Service Manual
4

















OFFMAN
PROGRAM
AUTO
1..6
1 2 3 4 5 6 7

LCD screen

Temperature change buttons

Holiday function button

Battery low indicator

Temperature enquiry button

Program buttons

Time display

Operating mode buttons

Copy day button

Burner on indicator

Green OK button

Set date/Day button

Day indicator

Battery compartment

Time change buttons

Temperature display

Battery cover

This section shows you how to setup and run the Hitachi room unit in 3 simple steps:


note
Please follow the instructions in this section only if the Hitachi room unit screen is blank (no symbols or digits -
are displayed). If the room temperature is already displayed move on to Step 2: Setting the date and time.
To install the batteries:
Lift up the front cover of the Hitachi room unit to reveal the battery cover and product controls.
Remove the battery cover by pressing down and sliding out.
Insertthe2xAALR6AlkalineBatteriessuppliedwiththeHitachiroomunit,ensuringthecorrectorientation(see
‘ControlsLayout’).
After a short pause the Hitachi room unit will display information on the screen and is now ready for use.
ReplacethebatterycoverbyslidingitrmlybackintothefrontoftheHitachiroomunit.