141
System MMI Pack (Room unit and RF receiver)
SMGB0066 rev.0 - 12/2009
Controller pack
Service Manual
4
To change the heating program:
Press either of the PROGRAM
or buttons to enter the programming mode. The time / temperature settings for
period1onMonday(Day1)willbeashingasshown.Theactiveperiodishighlightedbyaashingsquarearound
the numbers at the bottom of the screen and the selected day is shown with the day indicator.
Toadjusttheperiodstarttimeusethe or buttons,the‘OK?’indicatorwillbedisplayedtoconrmthe
change. Holding the button down will change the time quickly.
note
If you are pressing the -
or buttons and the display ashes the next period, it means the next period
will be pushed forward.
Once the required time is reached press the green buttontoconrm.
note
If the original time setting did not require adjustment press the green -
button to move to step ‘d’.
Thetemperaturesettingforperiod1onMonday(Day1)willnowbeashing.Toadjustthispressthe or
buttonsandconrmthesettingagainbypressingthegreen
button.
Thenexttimeandtemperatureperiodwillnowbeactive.Adjustthisbyrepeatingstepsb-daboveuntilall6periods
are set for Monday or press the buttontoruntheprogramasset,atanytime.
You now have a choice of how to set the program for the next day:
i) Press the button
tocopyMonday’sprogramintoTuesday.Thedisplaywillgoblankapartfromthe‘nonashing’
dayindicator,whichindicatesthedaycopiedandthe‘ashing’targetdaytocopytheprogramto.Toacceptthisday
press the green
button. To select a different target day press the buttonuntilthe‘ashing’dayindicatoris
undertherequiredday,thenacceptitbypressingthegreen
button.
note
Once the target day is conrmed it becomes the day that is copied if the -
button is pressed again.
OR ii) Press the buttontomovethedayindicatortoTuesday(Day2).Theprogramforthatdaycanthenbeadjusted
byfollowingstepsbtoe.Programsfortheremainingdayscanbesetinthesameway,usingthe
button to
move to the next day. To exit the programming mode select the desired operating mode by pressing the
, or
buttons.
To Next Page
Loading...
