Hitron CGNV - Resetting the CGNV

INTRODUCTION
Version 4.2.7.2, 05/2014. Copyright 2012 Hitron Technologies
26
Version 4.2.7.2, 05/2014. Copyright 2014 Hitron Technologies
26
Hitron CGNV User’s Guide
1.7 Resetting the CGNV
When you reset the CGNV to its factory defaults, all user-configured settings are lost,
and the CGNV is returned to its initial configuration state.
There are two ways to reset the CGNV:
Press the RESET button on the CGNV, and hold it in for ten seconds or longer.
Click Admin > Backup. In the screen that displays, click the Factory Reset
button.
The CGNV turns off and on again, using its factory default settings.
NOTE: Depending on your CGNV’s previous configuration, you may need to re-
configure your computer’s IP settings; see IP Address Setup on page 22.