Hitron CGNV - Adding or Editing a Port Forwarding Rule; On Page

BASIC
Version 4.2.7.2, 05/2014. Copyright 2012 Hitron Technologies
59
Version 4.2.7.2, 05/2014. Copyright 2014 Hitron Technologies
59
Hitron CGNV User’s Guide
4.5.1 Adding or Editing a Port Forwarding Rule
To add a new port forwarding rule, click Add in the Basic > Port Forwarding
screen.
To edit an existing port forwarding rule, select the rule’s radio button in the Basic
> Port Forwarding screen and click the Edit button.
Protocol This field displays the protocol or protocols to which this
rule applies:
Transmission Control Protocol (TCP)
User Datagram Protocol (UDP)
Transmission Control Protocol and User Datagram
Protocol (TCP/UDP)
Generic Routing Encapsulation (GRE)
Encapsulating Security Protocol (ESP)
Local IP Address This displays the IP address of the computer on the LAN
to which traffic conforming to the rule’s conditions is
forwarded.
Remote IP Address This displays the IP address range on the WAN from
which traffic is forwarded (if configured).
Status Use this field to turn port forwarding rule on or off.
Select ON to turn port forwarding rule on.
Select OFF to turn port forwarding rule off.
Add Click this to define a new port forwarding rule. Port
forwarding must first be set to Enabled. See Adding or
Editing a Port Forwarding Rule on page 59 for
information on the screen that displays.
Edit Select a port forwarding rule’s radio button and click this
to make changes to the rule. Port forwarding must first
be set to Enabled. See Adding or Editing a Port
Forwarding Rule on page 59 for information on the
screen that displays.
Delete Select a port forwarding rule’s radio button and click this
to remove the rule. The deleted rule’s information
cannot be retrieved.
Help Click this to see information about the fields in this
screen.
Table 18: The Basic: Port Forwarding Screen (continued)