Hitron CGNV - Table 24: the Wireless: Basic Settings Screen

WIRELESS
Version 4.2.7.2, 05/2014. Copyright 2012 Hitron Technologies
73
Version 4.2.7.2, 05/2014. Copyright 2014 Hitron Technologies
73
Hitron CGNV User’s Guide
The following table describes the labels in this screen.
Table 24: The Wireless: Basic Settings Screen
Basic Settings
Wireless Enabled Use this field to turn the wireless network on or off.
Select ON to enable the wireless network.
Select OFF to disable the wireless network.
Wireless Mode Select the type of wireless network that you want to use:
802.11 B/G Mixed: use IEEE 802.11b and 802.11n
802.11 11N Only: use IEEE 802.11n
802.11 B/G/N Mixed: use IEEE 802.11b, 802.11g
and 802.11n
802.11 G/N Mixed: use IEEE 802.11g and 802.11n
NOTE: Only wireless clients that support the network
protocol you select can connect to the wireless
network. If in doubt, use 11B/G/N (default).
Wireless Channel Select the wireless channel that you want to use, or
select Auto to have the CGNV select the optimum
channel to use.
NOTE: Use the Auto setting unless you have a specific
reason to do otherwise.
WPS Enabled Use this field to turn Wifi Protected Setup (WPS).
Select ON to enable WPS.
Deselect OFF to disable WPS.
WPS AP Pin This field displays the Wifi Protected Setup (WPS)
access point key the network.
Multiple SSID Settings - 2.4G Primary SSID
Network Name (SSID) Enter the name that you want to use for this SSID. This
is the name that identifies your network, and to which
wireless clients connect.
NOTE: It is suggested that you change the SSID from
its default, for security reasons.