Hitron CGNV - The Access Control Screen

WIRELESS
Version 4.2.7.2, 05/2014. Copyright 2012 Hitron Technologies
77
Version 4.2.7.2, 05/2014. Copyright 2014 Hitron Technologies
77
Hitron CGNV User’s Guide
5.4 The Access Control Screen
Use this screen to configure Media Access Control (MAC) address filtering on the
wireless network.
NOTE: To configure MAC address filtering on the wired LAN, see The Device Filter
Screen on page 100.
You can set the CGNV to allow only certain devices to access the CGNV and the
network wirelessly, or to deny certain devices access.
Encrypt Mode Select the type of encryption you want to use. The
options that display depend on the Security Mode you
selected.
WEP:
Select WEP64 to use a ten-digit security key.
Select WEP128 to use a twenty-six-digit security
key.
WPA, WPA2 and WPA/WPA2:
Select TKIP to use the Temporal Key Integrity
Protocol.
Select AES to use the Advanced Encryption
Standard.
Select TKIP/AES to allow clients using either
encryption type to connect to the CGNV.
Pass Phrase Enter the security key or password that you want to use
for your wireless network. You will need to enter this key
into your wireless clients in order to allow them to
connect to the network.
Save Changes Click this to save your changes to the fields in this
screen.
Cancel Click this to return the fields in this screen to their last-
saved values without saving your changes.
Help Click this to see information about the fields in this
screen.
Table 25: The Wireless: Security Settings Screen (continued)