BASIC
Version 4.2.7.2, 05/2014. Copyright 2012 Hitron Technologies
65
Version 4.2.7.2, 05/2014. Copyright 2014 Hitron Technologies
65
Hitron CGNV User’s Guide
4.7 The DMZ Screen
Use this screen to configure your network’s Demilitarized Zone (DMZ).
NOTE: Only one device can be on the DMZ at a time.
Click Basic > DMZ. The following screen displays.
Figure 24: The Basic: DMZ Screen
Protocol Use this field to specify whether the CGNV should
activate this trigger when it detects activity via:
Transmission Control Protocol (TCP)
User Datagram Protocol (UDP)
Transmission Control Protocol and User Datagram
Protocol (Both)
NOTE: If in doubt, leave this field at its default (Both).
Timeout (ms) Enter the time (in milliseconds) after the CGNV opens
the Target ports that it should close them.
Close Click this to return to the Firewall > Forwarding screen
without saving your changes to the port forwarding rule.
Apply Click this to save your changes to the fields in this
screen.
Table 21: The Basic: Port Triggering Add/Edit Screen
To Next Page
Loading...
