REGULATORY INFORMATION
xii
FIGURES AND DIAGRAMS
Illustrations in this publication are approximate representations of the actual equipment,
and may not be exactly as the equipment appears.
Figure 1. EOS | HD standard equipment ............................................................... 2
Figure 2. Base station front panel features .............................................................. 3
Figure 3. Base station rear panel features ............................................................... 4
Figure 4. Headset control buttons and indicator lights ..................................................... 5
Figure 5. Belt-pac control buttons and indicator lights ..................................................... 5
Figure 6. Correct wearing of the headset ................................................................ 6
Figure 7. Headset battery-release button................................................................ 6
Figure 8. Correct wearing of the headset ................................................................ 7
Figure 9. Battery Removal........................................................................... 7
Figure 10. Battery charger power adapter connection ....................................................... 8
Figure 11. Changing plug in international power adapter .................................................... 8
Figure 12. AC50 features and battery status guide ......................................................... 9
Figure 13. Typical drive-thru store layout ................................................................ 13
Figure 14. Typical tandem, Y-lane and dual drive-thru layouts ................................................ 14
Figure 15. Antenna mounting ......................................................................... 15
Figure 16. Power supply connection to base station ........................................................ 15
Figure 17. Open base station showing four screw holes...................................................... 19
Figure 18. Remote antenna mounting on wall bracket....................................................... 20
Figure 19. DM5 Microphone .......................................................................... 22
Figure 20. Placement of DM5 Microphone and foam in the foam enclosure ....................................... 22
Figure 21. Microphone unit in typical speaker post installation................................................ 22
Figure 22. SP10 with gasket and cable connector plug ...................................................... 23
Figure 23. SP10 in speaker post, menu board or enclosure ................................................... 23
Figure 24. Attach brackets to speaker................................................................... 24
Figure 25. Typical tandem drive-thru layout .............................................................. 91
Figure 26. S2 switch on Switcher Board ................................................................. 92
Figure 27. Base station internal connectors and controls .................................................... 95
Figure 28. Typical EOS | HD Base Station block diagram .................................................... 99
Figure 29. Full-Duplex Drive-Thru System with VDB but no Switcher Board (Lane 1 or Single Lane connections) .......... 103
Figure 30. Full-Duplex Drive-Thru System with VDB but no Switcher Board (Lane 2 connections) ..................... 104
Figure 31. Full-Duplex Drive-Thru System with VDB, Switcher Board and IC300 (Lane 1 or Single Lane connections) ...... 105
Figure 32. Full-Duplex Drive-Thru System with VDB, Switcher Board and IC300 (Lane 2 connections) .................. 106
Figure 33. Full-Duplex Drive-Thru System with VDB, Switcher Board and Microphone (Lane 1 or Single Lane connections) . . 107
Figure 34. Full-Duplex Drive-Thru System with VDB, Switcher Board and Microphone (Lane 2 connections) ............. 108
Figure 35. Half-Duplex Drive-Thru System with VDB but no Switcher Board (Lane 1 or Single Lane connections) .......... 109
Figure 36. Half-Duplex Drive-Thru System with VDB but no Switcher Board (Lane 2 connections) ..................... 110
Figure 37. Half-Duplex Drive-Thru System with VDB and Switcher Board (Lane 1 or Single Lane connections) ............ 111
Figure 38. Half-Duplex Drive-Thru System with VDB and Switcher Board (Lane 2 connections) ....................... 112
Figure 39. Optional Equipment........................................................................ 113
HM Electronics, Inc. is not responsible for equipment malfunctions due to erroneous translation of
its installation and / or operating publications from their original English versions.
© 2021 HM Electronics, Inc.
The HME logo and product names are registered trademarks of HM Electronics, Inc. All rights reserved.
US Patent 7,920,539; 9,484,041 and 9,639,906
To Next Page
Loading...