HME EOS HD - User Password Management

EOS
|
HD OPERATION
48
Set User Password
Set User Password
1. When you have completed all the other Store
Settings, set up a user password. When the
installation is nished, be sure to give the password to
the store manager.
To set a password for the rst time, press the Set
password button on the STORE SETTINGS display.

2. Use the ◄ and ► buttons to move the highlighted box
in the Enter new password eld.
Use the + button to put alphabetic characters in
the highlighted box, or the − button to put numeric
characters in the highlighted box.
Continuing down from A will take you to numeric
characters. Continuing up from 9 will take you to
alphabetic characters.
Press the ► button to move the highlighted box to
the next position and enter the next character. If you
want to start over with a new password, press the
Clear All button.
After entering the entire new password, press the
Back button twice to save the new password and
return to the ADVANCED MENU.




Press the B-to-Order Taker button on the STORE
SETTINGS display to select ✔ (on) to allow the Order
Taker to hear B button communication while pressing
an A button. If you select − (off), the Order Taker will
not hear B button communication while pressing an A
button.
To save this setting, press the Back button.

1 2 3 4 5 6 7 8 9
Introduction
EOS|HD
Equipment
EOS|HD
Operation
Audio Processing
Functions
Equipment Care
and Cleaning
Troubleshooting
Equipment
Specications
EOS|HD Message
Center Guide
Important
Notices