Honeywell FS24X Plus - Page 5

Honeywell® FS24XPlus™ | User Manual
5
Command #175: Set RTC (Time and Date) 83
Command #176: Read RTC (Time and Date) 84
Command #177: Configure HALO Mode for Alarm 85
Command #178: Read HALO Mode for Alarm 85
Command #179: Read Alarm, Warning State - Latch/Unlatch 86
Command #180: Start/End Inhibit 87
Command #181: Read Inhibit Timeout 87
Command #182: Configure Inhibit Timeout 88
Command #183: Read mA Configuration 89
Command #187: Read Force Timeout 90
Command #188: Configure Force Timeout 90
Command #189: Read Relay State 91
Command #190: Write Login 92
Command #191: Read Date Format 92
Command #192: Read Relay3 (Aux) Input Selection 93
Command #193: Set Relay3 (Aux) Input Selection 94
Command #195: Set Alarm Verification Time 94
Command #196: Write LED Intensity 95
Command #197: Read LED Intensity 96
Command #198: Read Serial Number 97
Common-Practice Commands 97
Tables 98
Performance 99
Appendix 6: Overview of the FS24X Plus™ Modbus Interface 100
Appendix 7: Fault Conditions 102
Appendix 8: Certifications and Approvals 103
Hazardous Area 103
Contact Us 107