Honeywell FS24X Plus - Command #137: Read Internal Commination Fault Status

Command #137: Read Internal Commination Fault Status
Reads Internal Commination Fault Status.
Request Data Bytes
Byte Format Description
None
Response Data Bytes
Byte Format Description
0 Enum
0 - If device has no internal commination fault
1 - If device has internal commination fault
Command-Specific Response Codes
Code Class Description
0 Success No Command-Specific Errors
1 Undefined
2 Error Invalid Selection
3 Error Parameter Too Large
4 Error Parameter Too Small
5 Error Too few data bytes received
6 Error Transmitter Specific Command Error
7 Error Write Protect Mode
8-15 Undefined
16 Error Access Restricted
17-31 Undefined
32 Error Busy
33-127 Undefined
Honeywell®FS24XPlus™ | User Manual
67