Honeywell FS24X Plus User Manual

Device-Specific Commands
The following device-specific commands are implemented:
Command Description
128 Read Fire Alarm Status
130 Read Device Status
135 Read Inhibit Status
136 Simulate 4-20 mA
137 Read Internal Commination Fault Status
138 Read Voltage Fault Status
139 Read Test Lamp Detection Status
140 Read Temperature
141 Read Voltage
142 Read All Sensor Readings
144 ReadModel
153 Read Device Alarm State
154 Set Detector Sensitivity
155 Read Detector Sensitivity
158 Set Relay Default State
159 Read Relay Default State
161 Reset Latch's
162 Set Password
164 Read Event History
165 Force Relay State
166 Force 4-20mA - Specific Loop Current
167 Force HALO State
168 Write mA Configuration
169 Configure Alarm, Warning State - Latch / Unlatch
172 Configure HALO Mode for Normal
173 Read HALO Mode for Normal
174 Set Date Format
175 Set RTC (Time and Date)
176 Read RTC (Time and Date)
177 Configure HALOMode for Alarm
178 Read HALO Mode for Alarm
179 Read Alarm, Warning State - Latch / Unlatch
180 Start / End Inhibit
181 Read Inhibit Timeout
182 Configure Inhibit Timeout
183 Read mA Configuration
187 Read Force Timeout
188 Configure Force Timeout
190 Write Login
Honeywell®FS24XPlus™ | User Manual
61

Honeywell FS24X Plus Specifications

General

Brand	Honeywell
Model	FS24X Plus
Category	Measuring Instruments
Language	English