Honeywell INNCOM e7w User Manual

INNCOM e7w THERMOSTAT USER GUIDE
31-00302-01
14
1
Target Temperature
Displays the current value of the desired temperature (SET). Also used to
display parameter in service mode.
2
Other Temperature
Displays the measured value of inside temperature, and outside temper-
ature when configured. Also, it displays the parameter value in service
mode.
3
Fan Speed
Displays the fan speed, there are five modes of fan speed.
Off
Low
Med
Hi
Auto
Off
Low Fan
Medium Fan
High Fan
Auto Fan Speed – Fan speed and heating or cooling are automatically
selected to raise, or lower room temperature based on the difference be-
tween the desired (SET) temperature shown on the display and the
measured room temperature.
Low/Medium/High Fan Speed – Low, Medium, and High fan speeds
are selected by pressing the fan button. The fan will run at the selected
speed in heating or cooling, in order to maintain desired (SET) tempera-
ture.
4
Heat Mode
Heat mode displayed, when the thermostat is configured only for heat
mode.
5
Cool Mode
Cool mode display, when the thermostat is configured only for cool
mode.
6
Outside Temperature
The outside temperature icon will be displayed next to the small seven
segment characters displaying the temperature, when outside air tem-
perature is enabled. Outside air temperature is displayed in dormant
mode only.
Note: This symbol also appears, when using the rEG CBL32 Registry Ed-
itor feature of the e7w to indicate a registry has been modified and
needs to be stored.

Honeywell INNCOM e7w Specifications

General

Brand	Honeywell
Model	INNCOM e7w
Category	Thermostat
Language	English