INNCOM e7w THERMOSTAT USER GUIDE
Use to configure the Room ID.
Use to configure the ZigBee pan used in radio communications.
Use to configure the channel used for IRAS communications.
Use to “Teach” IRAS device the unique identification information,
that binds to room or network.
Use to configure I/O Map on a remote device.
Use to view or edit the CBL32 Registry values of the CBL32 HVAC
thermostat or controller partner to the e7w such as a CBL32 X47.
Use to signal to connected devices and registers response. The
timeout duration of the ping is 1 minute.
Use to reset the thermostat- VAL 0 or remote device with specified
address or VAL
Use to verify WAN communication. Sends an event to the server.
The server in turn will reply with a command that lets the room ID
scroll over the display of the thermostat.
Use to verify Door sensor. The buzzer will sound as long as the
door is open, and the LCD counts the number of times the door
has gone from closed to open.
Use to verify PIR sensor. When Passive Infrared Motion (PIR) sen-
sor detects the guest motion, it plays buzzer sound and the LCD
counts the number of times the application has increased the
motion counter. The timeout duration is one minute.
Use to verify the monitored window/balcony/ position in the
guestroom. The buzzer will sound as long as the window/balcony
is open, and the LCD counts the number of times the window/bal-
cony changed from closed to open.
To Next Page
Loading...
Need help?
General
