Honeywell INNCOM e7w User Manual

INNCOM e7w THERMOSTAT USER GUIDE
61
31-00302-01
E7W – e7w Address Parameter (E7W)
The local address of e7w is by default 13 If required to change the e7w local address, use E7W pa-
rameter. You would need to change the e7w local address if it was required to have more than one
e7w installed in the same room. Each e7w must have a unique local address.
1. Enter SERVICE MODE
2. Press UP/DOWN arrow buttons to select E7W.
3. Press MODE button. This action displays E7W value.
4. Use the UP/DOWN arrow buttons to change the E7W value.
7. Press the FAN button to store the value. The e7w play beep sound.
8. Press the FC button to return SERVICE MODE or press UP arrow button to display next
mode
Or
Press the FC button twice to exit SERVICE MODE
OAT – Outside Air Temperature Parameter (oAt)
Use the OAT menu to Enable or Disable the ability of the e7w to display outside air temperature.
When the e7w is configured to display outside air temperature, it will only be displayed when the e7w
has entered “dormant” mode following 5 seconds of no user interaction with the e7w.
There must be an outside temperature sensor installed and the Inncom Server software configured to
report the outside temperature to the guest rooms.
E7
A
E7
A
Value
13

Honeywell INNCOM e7w Specifications

General

Brand	Honeywell
Model	INNCOM e7w
Category	Thermostat
Language	English