1. Enter SERVICE MODE
2. Press UP/DOWN arrow buttons to select OAT.
3. Press MODE button. By default, the ability of the e7w to display outside air temperature is
disabled and “n” (no) will displayed.
To enable, press the UP arrow button to change the “n” to “y” and press the FAN button to
store the change. The e7w will beep and return to the main OAT menu.
4. Press the FC button to return SERVICE MODE or press UP arrow button to display next
mode
5. With OAT enabled , anytime the e7w enters “dormant” mode, the measured outside temper-
ature will be displayed above the target temperature.
6. To disable the displaying outside air temperature on the e7w, when in “dormant” mode, re-
peat above steps 1-4, but in step 3 change the displayed “y” value to “n” value and press the
Fan button to store the change.
To Next Page
Loading...
Need help?
General
