a) After pressing FAN button, "bnd" will appear on the e7w display.
b) Press Bind button on target device, to make the target device send a Reverse Bind
Request to e7w.
c) Upon receiving the Reverse Bind Request, the e7w send a Bind offer to the target
device.
d) After the target device receives and accept the new address, the target device Re-
set and send message to e7w.
e) After receiving the message e7w beep three times to confirm the binding.
NOTE: For more details, refer applicable commissioning document.
Forward Binding
Forward binding is supported by devices such as an L208.RF, Evora, Modeva etc.
To configure using forward binding, follow the below steps.
a) Place the target device into a Bind Ready mode. This can be done by pressing any
button on the target device two times quickly, then press and hold the button for
5-7 seconds.
b) Press MODE button on e7w. The e7w send a Forward Bind Request.
c) After receiving the Forward Bind Request, the target device flashes LED confirm-
ing that it receives the Forward Bind Request.
• For binding RF devices, press bind button on the target device two times
quickly, then press and hold bind button for 5-7 seconds to accept the bind
request.
• For binding Non-RF devices, press bind button once on the target device to
accept the bind request.
d) After accepting the new address, the target device will Reset and send a “sound
buzzer” message to e7w.
e) After receiving the message, e7w beep three times as an audible indication that
the bind was successful.
6. Press the FC button to return SERVICE MODE or press UP arrow button to display
next mode.
To Next Page
Loading...
Need help?
General
