Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide 153
Bar Code Readers
The Thor VM1 can use the following external bar code readers:
• Tethered hand-held scanners are tethered to a serial port or a USB host port (via a
dongle cable) on the Thor VM1 dock and are configured by scanning the engine-
specific bar codes in the scanner manufacturer's programming guide. The
manufacturer's guides are usually shipped with the bar code reader.
• Wireless hand-held Bluetooth scanners are configured by scanning the engine-
specific bar codes in the scanner manufacturer's programming guide. The
manufacturer's guides are usually shipped with the bar code reader.
• The body worn Bluetooth Ring Scanner module may be using a Symbol 4400 Ring
Imager or a Symbol 955 Ring Scanner. The BTRS module is configured by scanning
the bar codes in the Bluetooth Ring Scanner Guide.
Scanner Wedge
Honeywell provides Freefloat Link*One for bar code decoding needs on the Thor VM1.
Refer to the Freefloat website for documentation on Freefloat Link*One.
Touch Screen Calibration
(Start) > Programs > PenMount Windows Universal Driver
To calibrate the touch screen, tap (Start) >Programs > PenMount Universal Driver >
Utility > PenMount Control Panel. Select PenMount 6000 USB and then tap Config-
ure. Select Standard Calibration or Advance Calibration.
Advanced Calibration allows the user to select the number of calibration points. With
either option, follow the on screen instructions to touch the red square, hold the touch
and then lift the stylus to complete the calibration process.
To Next Page
Loading...
Need help?
General
