220 Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide
After Latitude and Longitude Data are displayed, the user can tap Clipboard and the
latitude and longitude are copied to the clipboard cache. The data can be pasted into an
email, document or other electronic media.
About
OneClick Internet allows the user to configure the WWAN connection by entering basic
setup information. The network connection (service carrier) can be chosen based on the
firmware loaded, GPS tracking can be enabled and SMS messaging can be configured.
Once configured, OneClick Internet allows the user to connect or disconnect from the
mobile network.
System Requirements
OneClick Internet requires:
• Gobi 23000 3G Module (preinstalled by Honeywell)
• Gobi 23000 Driver package (loaded by Honeywell)
OneClick Internet for Gobi 23000is compatible with the following operating systems on
the Thor VM1:
• Windows Embedded Standard 7
• Windows 7 Professional
• Windows Embedded Standard 2009
Supported Languages
OneClick Internet supports the following languages:
German, English, Spanish, French, Polish, Russian, Italian, Simplified Chinese and Tra-
ditional Chinese.
Note: This does not mean that the Thor VM1 has been localized for these languages.
Installing or Upgrading OneClick Internet
Note: You must use the Honeywell supplied version of OneClick Internet. Do not change
versions unless instructed by your Honeywell representative.
One Click Internet is pre-installed before the Thor VM1 is shipped.
If you have an installed version of OneClick Internet and need to update to a newer ver-
sion, you must uninstall the previous version first by selecting Start > Control Panel >
Add or Remove Programs. Select OneClick Internet and tap Remove. Follow the on
screen instructions.
Note: OneClick Internet does not install the drivers for the Gobi 2000 devices. Device drivers are
preloaded.
To Next Page
Loading...
Need help?
General
