Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide 147
Screen Control
(Start) > Control Panel > Screen (Classic View)
Set screen properties for the Thor VM1.
Factory Default Settings
Note: If automatic brightness control is enabled for an outdoor display, the value for LCD
brightness depends on the Ambient Light %.
Note: There is no default value for Ambient Light % as it varies depending on the level of light
where the Thor VM1 is located.
Screen Blanking (Blackout)
Enable screen blanking Enabled
Screen on delay (ms) 1000
COM Port COM1
Automatic Brightness Control
(for outdoor display only)
Enable automatic brightness control Disabled
Low to medium light level (%) 25
Medium to high light level (%) 75
Current Level
LCD Brightness (%) 100 (see note)
Ambient Light (%) (see note)
Defroster Control
Enable defroster Disabled
Trip point (ºC) 40ºC
To Next Page
Loading...
Need help?
General
