50 Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide
Install RAM Mount
Before installation begins, verify you have the applicable vehicle mounting bracket
assembly components necessary, as shown in the following figures.
Components - RAM Mounting Kits
In addition to the kits below, individual RAM mounting components are also available.
Mounting Kits
Each mounting kit contains:
Caution: This device is intended to transmit RF energy. For protection
against RF exposure to humans and in accordance with FCC
rules and Industry Canada rules, this transmitter should be
installed such that a minimum separation distance of at least
20 cm (7.8 in.) is maintained between the antenna and the
general population. This device is not to be co-located with
other transmitters.
• RAM Ball (Size D) for back of Thor VM1 dock with
hardware (screws and washers) to attach RAM ball to
dock
• RAM Arm (Size D), length varies by kit selected
• One of three mounting options:
◦ RAM Ball mount (Size D, may include 3 cone
washers), or
◦ RAM Clamp mount (Size D), or
To Next Page
Loading...
Need help?
General
