Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide 159
Summit Tray Icon
The Summit tray icon is not shown when the Thor VM1 is running Windows Embedded
Standard 2009.
The Windows Wireless icon (located in the taskbar) may not display a successful wire-
less connection. The SCU Main tab should be used to verify the success of the connec-
tion instead.
Wireless Zero Config Utility
To Switch Control to the Wireless Zero Config Utility
1. Select ThirdPartyConfig in the Active Profile drop down box on the Main tab.
2. A message appears that a Power Cycle is required to make settings activate properly.
3. Tap OK.
4. Restart the Thor VM1.
The Summit Client Utility passes control to Wireless Zero Config and the WZC Wireless
Information control panel. Using the options in the Wireless Zero Config panels, set up
radio and security settings. There may be a slight delay before the Wireless Zero Config
icon indicates the status of the connection.
To Switch Control to SCU
1. To switch back to SCU control, select any other profile except ThirdPartyConfig in
the SCU Active Config drop down list on the Main tab.
2. A message appears that a Power Cycle is required to make settings activate properly.
3. Tap OK.
4. Restart the Thor VM1.
Radio control is passed to the SCU.
Main
Start > All Programs > Summit > Summit Client Utility > Main tab
• The WZC utility has an icon in the toolbar indicating the Wireless Zero Config
application is enabled but the connection is inactive at this time (the device is not
connected to a network). The WZC icon may not be visible until control is passed to
the WZC utility as described below.
• You can use either the Wireless Zero Configuration Utility or the Summit Client
Utility to connect to your network. The Summit Client Utility is recommended
because the Wireless Zero Configuration Utility cannot control the complete set of
security features of the radio.
To Next Page
Loading...
Need help?
General
