Honeywell Vuquest 3320g - Code 93 Append; Code 93 Code Page

Vuquest 3320g User Guide 105
Code 93 Append
This function allows the scanner to append the data from several Code 93
barcodes together before transmitting them to the host computer. When this
function is enabled, the scanner stores those Code 93 barcodes that start with a
space (excluding the start and stop symbols), and does not immediately transmit
the data. The scanner stores the data in the order in which the barcodes are read,
deleting the first space from each. The scanner transmits the appended data when
it reads a Code 93 barcode that starts with a character other than a space. Default =
Off.
Code 93 Code Page
Code pages define the mapping of character codes to characters. If the data
received does not display with the proper characters, it may be because the
barcode being scanned was created using a code page that is different from the
one the host program is expecting. If this is the case, scan the barcode below,
select the code page with which the barcodes were created (see Symbology Charts
on page 211), and scan the value and the Save barcode from the Programming
Chart, beginning on page 222. The data characters should then appear properly.
On
* Off
Code 93 Code Page