46 Vuquest 3320g User Guide
Character Activation Mode
You may use a character sent from the host to trigger the scanner to begin
scanning. When the activation character is received, the scanner continues
scanning until either the Character Activation Laser Timeout on page 46, the
deactivation character is received (see Deactivation Character on page 48), or a
barcode is transmitted. Scan the following On barcode to use character activation,
then use Activation Character (following) to select the character you will send from
the host to start scanning. Default = Off.
Activation Character
This sets the character used to trigger scanning when using Character Activation
Mode. On the ASCII Conversion Chart (Code Page 1252) on page 214, find the hex
value that represents the character you want to use to trigger scanning. Scan the
following barcode, then use the Programming Chart, beginning on page 222, to
read the alphanumeric combination that represents that ASCII character. Scan
Save to finish.
Character Activation Laser Timeout
You can set a timeout for the length of time the laser remains On and attempting to
decode barcodes when using Character Activation Mode. Set the length (in
milliseconds) for a timeout by scanning the following barcode, then setting the
timeout (from 1-65535 milliseconds) by scanning digits from the Programming
Chart, beginning on page 222, then scanning Save. Default = 5000 ms.
Character Activation Laser
Timeout
To Next Page
Loading...
