12 Vuquest 3320g User Guide
Honeywell Bioptic Aux Port Configuration
Scan the following Plug and Play code to program the scanner for a Honeywell
bioptic scanner auxiliary port configuration. This barcode sets the baud rate to
38400 bps and the data format to 8 data bits, no parity, 1 stop bit.
Note: If you are having unexpected results with this programming code, scan the Activate
Defaults barcode on page 6 first, then scan the programming code above.
Datalogic™ Magellan
©
Aux Port Configuration
Scan the following Plug and Play code to program the scanner for a Datalogic
Magellan auxiliary port configuration. This barcode sets the baud rate to 9600 bps
and the data format to 8 data bits, no parity, 1 stop bit.
Note: If you are having unexpected results with this programming code, scan the Activate
Defaults barcode on page 6 first, then scan the programming code above.
NCR Bioptic Aux Port Configuration
Scan the following Plug and Play code to program the scanner for an NCR bioptic
scanner auxiliary port configuration. The communication should be set at
9600bps baud rate, 7 data bit data format, even parity, and 1 stop bit. The following
prefixes are programmed for each symbology:
Honeywell Bioptic Settings
Datalogic Magellan Bioptic Settings
Symbology Prefix Symbology Prefix
UPC-A A Interleaved 2 of 5 b
UPC-E E0 Code 128 f
GS1 DataBar
Omnidirectional
r
EAN-8 FF GS1 DataBar
Expanded
r
EAN-13 F Codabar N
Code 39 a Code 32
Pharmaceutical
(PARAF)
a
To Next Page
Loading...
