Vuquest 3320g User Guide 117
Coupon GS1 DataBar Output
If you scan coupons that have both UPC and GS1 DataBarcodes, you may wish to
scan and output only the data from the GS1 DataBarcode. Scan the GS1 Output On
code below to scan and output only the GS1 DataBarcode data. Default = GS1
Output Off.
UPC-E0
<Default All UPC-E Settings>
UPC-E0 On/Off
Most U.P.C. barcodes lead with the 0 number system. To read these codes, use the
UPC-E0 On selection. If you need to read codes that lead with the 1 number
system, use UPC-E1 on page 119. Default = On.
UPC-E0 Expand
UPC-E Expand expands the UPC-E code to the 12 digit, UPC-A format. Default =
Off.
To Next Page
Loading...
