50 Vuquest 3320g User Guide
Aimer Delay
The aimer delay allows a delay time for the operator to aim the scanner before the
picture is taken. Use these codes to set the time between when the button is
pushed and when the picture is taken. During the delay time, the aiming light will
appear, but the LEDs won’t turn On until the delay time is over. Default = Off.
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the barcode
below, then set the time-out by scanning digits (0 - 4,000 ms) from the
Programming Chart, beginning on page 222, then scan Save.
Aimer Mode
This feature allows you to turn the aimer On and Off. When the Interlaced barcode
is scanned, the aimer is interlaced with the illumination LEDs. Default = Interlaced.
To Next Page
Loading...
