Vuquest 3320g User Guide 169
UTILITIES
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn On transmission of a Code I.D. before the decoded
symbology. See the Symbology Charts, beginning on page 211) for the single
character code that identifies each symbology. This action first clears all current
prefixes, then programs a Code I.D. prefix for all symbologies. This is a temporary
setting that will be removed when the unit is power cycled.
Show Decoder Revision
Scan the barcode below to output the decoder revision.
Note: This command is not supported with the Gen 7 software revision. For infomation
about software revisions, see About Software Revisions on page 6.
Add Code I.D. Prefix to
All Symbologies (Temporary)
To Next Page
Loading...
