48 Vuquest 3320g User Guide
Deactivation Character
This sets the character used to terminate scanning when using Character
Deactivation Mode. On the ASCII Conversion Chart (Code Page 1252) on page 214,
find the hex value that represents the character you want to use to terminate
scanning. Scan the following barcode, then use the Programming Chart, beginning
on page 222, to read the alphanumeric combination that represents that ASCII
character. Scan Save to finish.
Reread Delay
This sets the time period before the scanner can read the same barcode a second
time. Setting a reread delay protects against accidental rereads of the same
barcode. Longer delays are effective in minimizing accidental rereads. Use shorter
delays in applications where repetitive barcode scanning is required. Reread Delay
only works when in a Presentation Mode (see page 40). Default = Medium.
User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the barcode below,
then set the delay (from 0-65,535 milliseconds) by scanning digits from the
Programming Chart, beginning on page 222, then scanning Save.
User-Specified Reread Delay
To Next Page
Loading...
