40 Vuquest 3320g User Guide
Read Time-Out
Use this selection to set a time-out (in milliseconds) of the scanner’s button when
using serial commands to trigger the scanner. Once the scanner has timed out, you
can activate the scanner either by pushing the button or using a serial trigger
command. After scanning the Read Time-Out barcode, set the time-out duration
(from 0-300,000 milliseconds) by scanning digits from the Programming Chart,
beginning on page 222, then scanning Save. Default = 30,000 ms.
Presentation Mode
Presentation Mode uses ambient light and scanner illumination to detect
barcodes. When in Presentation Mode, the LEDs remain dim until a barcode is
presented to the scanner, then the aimer turns On and the LEDs turn up to read the
code. If the light level in the room is not high enough, Presentation Mode may not
work properly.
Scan the following barcode to program your scanner for Presentation Mode.
To Next Page
Loading...
