Vuquest 3320g User Guide 39
LED Illumination Exposure Mode - Manual Trigger
For scanners with the Gen 7 software revision that are using Manual Trigger Mode,
you must first scan the Set Exposure Mode - Manual Trigger Mode barcode before
scanning one of the LED Illumination - Manual Trigger barcodes.
Default = Automatic Exposure - Manual Trigger Mode.
Note: For infomation about software revisions, see About Software Revisions on page 6.
LED Illumination Exposure Mode - Presentation Mode
For scanners with the Gen 7 software revision that are using Presentation Mode,
you must first scan the Set Exposure Mode - Presentation Mode barcode before
scanning one of the LED Illumination - Manual Trigger barcodes.
Default = Automatic Exposure - Presentation Mode.
Note: For infomation about software revisions, see About Software Revisions on page 6.
Serial Trigger Mode
You can activate the scanner either by pushing the button, or using a serial trigger
command (see Trigger Commands on page 178). When in serial mode, the scanner
scans until a barcode has been read or until the deactivate command is sent. The
scanner can also be set to turn itself Off after a specified time has elapsed (see
Read Time-Out, which follows).
* Automatic Exposure - Manual Trigger Mode
Set Exposure Mode - Manual Trigger Mode
* Automatic Exposure - Presentation Mode
Set Exposure Mode - Presentation Mode
To Next Page
Loading...
