Vuquest 3320g User Guide 65
Intercharacter, Interfunction, and Intermessage Delays
Some terminals drop information (characters) if data comes through too quickly.
Intercharacter, interfunction, and intermessage delays slow the transmission of
data, increasing data integrity.
Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each character of scanned data. Scan the
Intercharacter Delay barcode below, then scan the number of 5ms delays, and the
Save barcode using the Programming Chart, beginning on page 222.
To remove this delay, scan the Intercharacter Delay barcode, then set the number
of delays to 0. Scan the Save barcode using the Programming Chart, beginning on
page 222.
Note: Intercharacter delays are not supported in USB serial.
User Specified Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed after the transmission of a particular character of scanned data. Scan the
Delay Length barcode below, then scan the number of 5ms delays, and the Save
barcode from the Programming Chart, beginning on page 222.
Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value for a
printable character to trigger the delay (see Symbology Charts on page 211).
To remove this delay, scan the Delay Length barcode, and set the number of delays
to 0. Scan the Save barcode from the Programming Chart, beginning on page 222.
1 2345
Intercharacter Delay
Prefix Scanned Data Suffix
Intercharacter Delay
Character to Trigger Delay
To Next Page
Loading...
