Honeywell Vuquest 3320g - Page 92

76 Vuquest 3320g User Guide
Move the cursor forward 3 characters, then send the rest of the barcode data from
the barcode above. End with a carriage return.
Command string: F503F10D
F5 is the “Move the cursor forward a number of characters” command
03 is the number of characters to move the cursor
F1 is the “Send all characters” command
0D is the hex value for a CR
The data is output as:
4567890ABCDEFGHIJ
<CR>
Move the cursor backward a number of characters
F6 Move the cursor back “nn” characters from current cursor position.
Syntax = F6nn, where nn is the numeric value (00-99) for the number of characters
the cursor should be moved back.
Move the cursor to the beginning
F7 Move the cursor to the first character in the input message. Syntax = F7.
FE and F7 Example: Manipulate barcodes that begin with a 1
Search for barcodes that begin with a 1. If a barcode matches, move the cursor
back to the beginning of the data and send 6 characters followed by a carriage
return. Using the barcode above:
Command string: FE31F7F2060D
FE is the “Compare characters” command
31 is the hex value for 1
F7 is the “Move the cursor to the beginning” command
F2 is the “Send a number of characters” command
06 is the number of characters to send
0D is the hex value for a CR
The data is output as:
123456
<CR>