HORNER XLE-Model 2 User Manual

MAN0878-09-EN_XLE_XLT_UserManual
A u g u s t 2 3 , 2 0 1 8 P a g e 104 | 158
Figure 13.4—Alarm Configuration in Cscape
To view, acknowledge, and/or clear alarms, the operator must access the alarm viewer. This is
accomplished by selecting an alarm object. When accessed, the alarm object is displayed as
pop-up alarm viewer dialog similar to that shown in Figure 13.5. If more entries exist than can
fit on the page, a scroll bar is displayed on the right side that also indicates the current
relative position.
Figure 13.5 – Alarm Object
Once view operations are complete, simply touch the Esc button to remove the pop-up alarm
viewer.
NOTE: OCS registers %SR181 and %SR182 are available for ladder use, which indicate
presence of unacknowledged or acknowledged alarm (respectively). The screen designer may
implement these registers to switch screens or activate the beeper to attract the operator’s
attention.

HORNER XLE-Model 2 Specifications

General

Brand	HORNER
Model	XLE-Model 2
Category	Controller
Language	English