HORNER XLE-Model 2 User Manual

MAN0878-09-EN_XLE_XLT_UserManual
A u g u s t 2 3 , 2 0 1 8 P a g e 111 | 158
14.3 Register Map for XLE/XLT I/O
Table 14.3 – I/O Register Map
Registers
Description
XLE/XLT
with
no I/O
XLE/XLT with
102 I/O
XLE/XLT with
103 I/O
XLE/XLT with
104 I/O
XLE/XLT with
105 I/O
XLE/XLT with
106 I/O
%I1-%I12
Unused
Digital Inputs
%I13-%I16
Unused
Reserved
Digital Inputs
Reserved
%I17-%I24
Unused
Reserved
Digital Inputs
Reserved
%I25-%I29
Unused
Reserved
%I30-%I31
Unused
PWM Table
1
%I32
Unused
ESCP Alarm*
%Q1
Unused
PWM Table
1
%Q1-%Q6
Unused
Digital Outputs
%Q7-%Q12
Unused
Reserved
Digital Outputs
%Q13-%Q16
Unused
Reserved
Digital Outputs
Reserved
%Q17-%Q20
Unused
HSC Table
2
%Q21-%Q24
Unused
Reserved
%AI1-%AI2
Unused
HSC Table
2
%AI33 - %AI38
Unused
Analog Inputs
%AQ1-%AQ8
Unused
PWM Table*
%AQ9-%AQ10
Unused
Analog Outputs
Unused = These registers can be used as general purpose registers
1
PWM Table is in Section 12.5 in the High Speed I/O (HSC/PWM) Chapter.
2
HSC Table is in Section 12.3 in the High Speed I/O (HSC/PWM) Chapter.
*
Electronic Short Circuit Protection [ESCP]
NOTE: The ESCP bit is set high when the output current is too high, and the output driver has
shut down for thermal protection. This typically happens when outputs are shorted, or they
are driving loads that are higher than the output rating.

HORNER XLE-Model 2 Specifications

General

Brand	HORNER
Model	XLE-Model 2
Category	Controller
Language	English