HORNER XLE-Model 2 User Manual

MAN0878-09-EN_XLE_XLT_UserManual
A u g u s t 2 3 , 2 0 1 8 P a g e 138 | 158
CHAPTER 17: CLONE UNIT
17.1 Overview
The ‘Clone Unit’ feature allows the user to “clone” the OCS of the exact same model. This
feature “clones” application program and unit settings stored in Battery backed RAM of an OCS
into the RM (refer Removable Media Chapter 10 for details on using RM). It can then be used to
clone a different OCS (exact same model).
This feature can be used for:
• Replacing an OCS by another unit of the same model.
• Duplicating or “clone” units without a PC.
17.2 Clone
User must perform the following sequence of action to Clone a unit:
1. The ‘Clone Unit’ can be accessed by going to the ‘System Menu’ of the OCS. A new menu
“Clone Unit” has been added at the end of the main system menu as shown below:
XLT:
XLE:
Figure 17.1– System Menu
2. Selecting “Clone Unit” menu will open the following menu screen:
XLT:
XLE:
Figure 17.2 – Clone Unit Menu before Cloning

HORNER XLE-Model 2 Specifications

General

Brand	HORNER
Model	XLE-Model 2
Category	Controller
Language	English