HP 5920 Series Configuration Guide

108
b. Select Access Service > Portal Service Management > Server from the navigation tree to enter
the portal server configuration page, as shown in Figure 38.
c. Config
ure the portal server parameters as needed.
This example uses the default values.
d. Click OK.
Figure 38 Portal authentication server configuration
2. Configure the IP address group:
a. Select Access Service > Portal Service Management > IP Group from the navigation tree to
enter the portal IP address group configuration page.
b. Click Add to enter the page shown in Figure 39.
c. Enter the IP group name.
d. Enter the start IP address and end IP add
ress of the IP
group.
Make sure the host IP address (2.2.2.2) is in the IP group.
e. Select a service group.
This example uses the default group Ungrouped.
f. Select Normal from the Action list.
g. Click OK.
Figure 39 Adding an IP address group
3. Add a portal device:
a. Select Access Service > Portal Service Management > Device from the navigation tree to enter
the portal device configuration page.

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English