HP 5920 Series Configuration Guide

190
Ste
p
Command Remarks
3. Specify the trusted CA.
ca identifier name
By default, no trusted CA is
specified.
To obtain a CA certificate, the
trusted CA name must be provided.
The trusted CA name uniquely
identifies the CA to be used if
multiple CAs exist on the same CA
server. The CA server's URL is
specified by using the certificate
request url command.
4. Specify the PKI entity
name.
certificate request entity entity-name By default, no entity is specified.
5. Specify the type of
certificate request
reception authority.
certificate request from { ca | ra }
By default, no authority is
specified.
6. Specify the certificate
request URL.
certificate request url url-string
[ vpn-instance vpn-instance-name ]
By default, the certificate request
URL is not specified.
Do not configure this command
when you request a certificate in
offline mode.
7. (Optional.) Set the
SCEP polling interval
and maximum number
of polling attempts.
certificate request polling { count count |
interval minutes }
By default, the device polls the CA
server for the certificate request
status every 20 minutes. The
maximum number of polling
attempts is 50.
8. Specify the LDAP
server.
ldap-server host hostname [ port
port-number ] [ vpn-instance
vpn-instance-name ]
This task is required only when the
CRL repository is an LDAP server
and the URL of the CRL repository
does not contain the host name of
the LDAP server.
By default, no LDAP server is
specified.

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English