249
Verifying the configuration
After the previous configurations, Switch A, Switch B, and Switch C learn IPv6 routing information
through RIPng. IPsec SAs are set up successfully on the switches to protect RIPng packets. The following
example uses Switch A to illustrate how to view the IPsec-related information.
# Use the display ripng command to display the RIPng configuration. The output shows that the IPsec
profile profile001 has been applied to RIPng process 1.
[SwitchA] display ripng 1
RIPng process : 1
Preference : 100
Checkzero : Enabled
Default Cost : 0
Maximum number of balanced paths : 8
Update time : 30 sec(s) Timeout time : 180 sec(s)
Suppress time : 120 sec(s) Garbage-Collect time : 120 sec(s)
Number of periodic updates sent : 186
Number of trigger updates sent : 1
IPsec profile name: profile001
# Use the display ipsec sa command to display the established IPsec SAs.
[SwitchA] display ipsec sa
-------------------------------
Global IPsec SA
-------------------------------
-----------------------------
IPsec profile: profile001
Mode: manual
-----------------------------
Encapsulation mode: transport
[Inbound ESP SA]
SPI: 123456 (0x3039)
Transform set: ESP-ENCRYPT-AES-CBC-128 ESP-AUTH-SHA1
No duration limit for this SA
[Outbound ESP SA]
SPI: 123456 (0x3039)
Transform set: ESP-ENCRYPT-AES-CBC-128 ESP-AUTH-SHA1
No duration limit for this SA
To Next Page
Loading...
Need help?
General
