HP 5920 Series Configuration Guide

20
{ For other types of local users, no authorization attributes are effective.
To configure local user attributes:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Add a local user and enter
local user view.
local-user user-name [ class
{ manage | network } ]
By default, no local user exists.
3. (Optional.) Configure a
password for the local
user.
• For a network access user:
password { cipher | simple }
password
• For a device management user:
{ In non-FIPS mode:
password [ { hash | simple }
password ]
{ In FIPS mode:
password
Network access user passwords are
encrypted with the encryption
algorithm and saved in ciphertext.
Device management user passwords
are encrypted with the hash
algorithm and saved in ciphertext.
In non-FIPS mode, a
non-password-protected user passes
authentication if the user provides the
correct username and passes
attribute checks. To enhance security,
configure a password for each local
user.
In FIPS mode, only
password-protected users can pass
authentication.
4. Assign services to the local
user.
• For a network access user:
service-type { lan-access |
portal }
• For a device management user:
{ In non-FIPS mode:
service-type { ftp | { http |
https | ssh | telnet |
terminal } * }
{ In FIPS mode:
service-type { https | ssh |
terminal } *
By default, no service is authorized to
a local user.
5. (Optional.) Place the local
user to the active or
blocked state.
state { active | block }
By default, a created local user is in
active state and can request network
services.
6. (Optional.) Set the upper
limit of concurrent logins
using the local user name.
access-limit max-user-number
By default, the number of concurrent
logins is not limited for the local user.
This command takes effect only when
local accounting is configured for the
local user. It does not apply to FTP,
SFTP, or SCP users, who do not
support accounting.

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English