HP 5920 Series Configuration Guide

38
• If the secondary server is unreachable, the device does the following:
{ Changes the server's status to blocked.
{ Starts a quiet timer for the server.
{ Tries to communicate with the next secondary server in active state that has the highest priority.
• The search process continues until the device finds an available secondary server or has checked
all secondary servers in active state. If no server is available, the device considers the authentication,
authorization, or accounting attempt a failure.
• When the quiet timer of a server expires, the status of the server changes back to active. The device
does not check the server again during the authentication, authorization, or accounting process.
• When you remove a server in use, communication with the server times out. The device looks for a
server in active state by first checking the primary server, and then checking secondary servers in
the order they are configured.
• When the primary server and secondary servers are all in blocked state, the device tries to
communicate with the primary server.
• When one or more servers are in active state, the device tries to communicate with these servers
only, even if they are unavailable.
• When the status of an HWTACACS server changes automatically, the device changes the status of
this server accordingly in all HWTACACS schemes in which this server is specified.
To set HWTACACS timers:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter HWTACACS scheme
view.
hwtacacs scheme
hwtacacs-scheme-name
N/A
3. Set the HWTACACS server
response timeout timer.
timer response-timeout seconds
By default, the HWTACACS server
response timeout timer is 5
seconds.
4. Set the real-time accounting
interval.
timer realtime-accounting minutes
By default, the real-time accounting
interval is 12 minutes.
A short interval helps improve
accounting precision but requires
many system resources. When
there are 1000 or more users, set a
longer interval.
5. Set the server quiet timer.
timer quiet minutes
By default, the server quiet timer is
5 minutes.
Displaying and maintaining HWTACACS
Execute the display command in any view and the reset command in user view.
Task Command
Display the configuration or server
statistics of HWTACACS schemes.
display hwtacacs scheme [ hwtacacs-server-name [ statistics ]
Clear HWTACACS statistics.
reset hwtacacs statistics { accounting | all | authentication |
authorization }

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English