DRAFT - HP Confidential - DRAFT
Removal and replacement procedures 76
2. Remove the server from the rack (on page 27).
3. Remove the access panel ("Access panel" on page 36).
4. Remove the air baffle ("Air baffle" on page 37).
5. Open the cable management holder (on page 32).
6. Pull down the front drive cage release latches and use them to completely extend the front drive cages
from the chassis.
7. Disconnect all system cables secured in the cable management holder from the system board or
controller board, and then release them from the holder.
8. Press and hold the cable management holder release latch, and then move the holder up.
To Next Page
Loading...
Need help?
General