DRAFT - HP Confidential - DRAFT
Removal and replacement procedures 30
b. Pull on the chassis ear thumbscrews to extend the server out of the rack until the rack rail lock is
engaged.
c. Press the server release latches, and remove the server from the rack.
10. Place the server on a sturdy, level surface.
Remove the PCI riser cage
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives, power input
modules, and the internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
To remove the component:
1. Power down the server (on page 17).
To Next Page
Loading...
Need help?
General