EasyManuals Logo

HP FlexNetwork MSR2003 User Manual

HP FlexNetwork MSR2003
517 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #168 background imageLoading...
Page #168 background image
154
[Router-acl-ipv4-basic-2000] rule permit source 192.168.1.0 0.0.0.255
[Router-acl-ipv4-basic-2000] quit
# Create address group 1.
[Router] nat address-group 1
# Add address 202.38.1.2 to the address group.
[Router-address-group-1] address 202.38.1.2 202.38.1.2
[Router-address-group-1] quit
# Create address group 2.
[Router] nat address-group 2
# Add address 202.38.1.3 to the address group.
[Router-address-group-2] address 202.38.1.3 202.38.1.3
[Router-address-group-2] quit
# Configure NAT Server on interface GigabitEthernet 2/0/2 to allow external hosts to access the
internal DNS server by using the address 202.38.1.4.
[Router] interface gigabitethernet 2/0/2
[Router-GigabitEthernet2/0/2] nat server protocol udp global 202.38.1.4 inside
192.168.1.3 dns
# Enable outbound NO-PAT on interface GigabitEthernet 2/0/2 to translate IP address of the Web
server in the DNS response payload into the address in address group 1, and allow reversible NAT.
[Router-GigabitEthernet2/0/2] nat outbound 2000 address-group 1 no-pat reversible
# Enable inbound PAT on interface GigabitEthernet 2/0/2 to translate the source address of packets
going to the internal network to the address in address group 2.
[Router-GigabitEthernet2/0/2] nat inbound 2000 address-group 2
[Router-GigabitEthernet2/0/2] quit
# Configure a static route to 202.38.1.3 with GigabitEthernet 2/0/2 as the output interface and
20.2.2.2 as the next hop. (The next hop address varies by network.)
[Router] ip route-static 202.38.1.3 32 gigabitethernet 2/0/2 20.2.2.2
Verifying the configuration
# Verify that the host on the external network can use the domain name to access the internal Web
server whose address is the same as the host. (Details not shown.)
# Display all NAT configuration and statistics.
[Router] display nat all
NAT address group information:
Totally 2 NAT address groups.
Address group 1:
Port range: 1-65535
Address information:
Start address End address
202.38.1.2 202.38.1.2
Address group 2:
Port range: 1-65535
Address information:
Start address End address
202.38.1.3 202.38.1.3
NAT inbound information:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP FlexNetwork MSR2003 and is the answer not in the manual?

HP FlexNetwork MSR2003 Specifications

General IconGeneral
BrandHP
ModelFlexNetwork MSR2003
CategoryNetwork Router
LanguageEnglish

Related product manuals