EasyManua.ls Logo

HP FlexNetwork MSR2003

HP FlexNetwork MSR2003
517 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
155
Totally 1 NAT inbound rules.
Interface: GigabitEthernet2/0/2
ACL: 2000 Address group: 2 Add route: N
NO-PAT: N Reversible: N
Config status: Active
Global flow-table status: Active
NAT outbound information:
Totally 1 NAT outbound rules.
Interface: GigabitEthernet2/0/2
ACL: 2000 Address group: 1 Port-preserved: N
NO-PAT: Y Reversible: Y
Config status: Active
Global flow-table status: Active
NAT internal server information:
Totally 1 internal servers.
Interface: GigabitEthernet2/0/2
Protocol: 17(UDP)
Global IP/port: 202.38.1.4/53
Local IP/port : 200.1.1.3/53
Config status : Active
Global flow-table status: Active
Local flow-table status: Active
NAT logging:
Log enable : Disabled
Flow-begin : Disabled
Flow-end : Disabled
Flow-active : Disabled
Port-block-assign : Disabled
Port-block-withdraw : Disabled
Alarm : Disabled
NAT mapping behavior:
Mapping mode : Address and Port-Dependent
ACL : ---
Config status: Active
NAT ALG:
DNS : Enabled
FTP : Enabled
H323 : Enabled
ICMP-ERROR : Enabled
ILS : Enabled
MGCP : Enabled
NBT : Enabled
PPTP : Enabled

Table of Contents

Related product manuals