CLI commands
LAN IP interface context
Path: View > Enable > Config > LAN IP interface
This context provides commands for configuring various IP-networking related settings for the
LAN interface.
end
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
end
Switches to parent context.
ip address
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ip address <ip address>/<mask>
Sets a static IP address for the port.
Parameters
<address> IP address.
</mask> Subnet mask in CIDR format. Specifies the number of bits in the mask.
ip address management
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ip address management <ip address>/<mask>
Sets a management IP address for this device.
Parameters
<address> IP address.
</mask> Subnet mask in CIDR format. Specifies the number of bits in the mask.
passive-interface
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
passive-interface
Sets RIP to operate in passive mode (listen for routing broadcasts to update the routing table, but
do not broadcast own routes).
no passive-interface
Sets RIP to operate in active mode (listen for routing broadcasts to update the routing table, and
also broadcast own routes).
router rip
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
router rip
Enable RIP.
2-84
To Next Page
Loading...
Need help?
General
