CLI commands
View context
Path: View
This is the root of the command tree.
arping
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
arping [ -AbDfhqUV] [ -c <count>] [ -w <deadline>] [ -s <source>] -I <interface>
<destination>
Pings a destination on a device interface using ARP packets.
enable
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
enable
Switches to the enable context.
iperf
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
iperf -c host [-t time]
Runs a performance throughput test.
Parameters
<-c host> The IP address or DNS name of the iperf server to connect to.
<-t length> Length of the throughput test in seconds.
nslookup
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
nslookup [ -option authentication ] [ <host-to-find> | - [< server> ]]
Queries DNS servers for information on hosts or domains.
ping
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
ping <host> [-c <count>] [-s <length>] [-q]
Determines if the specified remote IP address is active.
Parameters
<-c host> The IP address or DNS name of the host to ping.
<-c count> Number of pings.
<-s length> Length of the ping datagram.
<-q> Quiet mode. No output.
2-2
To Next Page
Loading...
Need help?
General
