CLI commands
Switch port context
Path: View > Enable > Controlled Network AP > Controlled Network > Switch port
View > Enable > Controlled Network AP Group > Controlled Network > Switch port
View > Enable > Controlled Network Base Group > Controlled Network > Switch port
Switch port configuration.
Note The commands in this context are used to perform configuration of the Ethernet switch built
|
into the MSM317 Access Device.
end
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
end
Back to parent context.
active
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
active
Activate this port.
no active
Deactivate this port.
authentication profile vsc
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
authentication profile vsc <name>
Set the VSC (Virtual AP) to use for authentication.
use authentication profile vsc
Use the VSC (Virtual AP) for authentication.
no use authentication profile vsc
Ignore the VSC (Virtual AP) for authentication.
authentication server radius
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
authentication server radius <name>
Select RADIUS profile to use.
dot1x authentication
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
dot1x authentication
Enable support for IEEE802.1X.
2-160
To Next Page
Loading...
Need help?
General
