CLI commands
Virtual AP context
Path: View > Enable > Config > Virtual AP
This context provides commands for configuring Virtual AP profiles (VAP (VSC)s).
By default one profile exists with the name "". This is the default profile and cannot be deleted.
The following example shows how to add a new VAP (VSC) with egress mapped to an existing
VLAN named "hongkong":
CLI(config)# virtual ap newap
CLI(virtual-ap)# access control
CLI(virtual-ap)# egress any vlan hongkong
CLI(virtual-ap)# ssid name "newap"
CLI(virtual-ap)# ingress ssid
CLI(virtual-ap)# bandwidth high
CLI(virtual-ap)# end
CLI(config)#
virtual ap name
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
virtual ap name <name>
Change the VAP (VSC) name.
access control
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
access control
Sets this profile to use the services of the service controller’s access control mechanism for
authentication and control of client sessions.
no access control
Do not provide access control with this VAP (VSC).
When enabled
îš„ The service controller provides a variety of methods for user authentication, including: MAC,
802.1x, and HTML via either the local user list or a RADIUS server.
îš„ Egress traffic can be routed based on the user state: authenticated, unauthenticated, or
intercepted.
When disabled
îš„ The service controller does not perform user authentication, either via RADIUS or the local
user list. All authentication must be handled by a remote device.
îš„ All wireless traffic is bridged to an egress VLAN.
îš„ No access controller functions are available. This means no support for RADIUS attributes for
the service controller.
îš„ 802.1x support is available, including support for RADIUS attributes for users.
2-87
To Next Page
Loading...
Need help?
General
