CLI commands
If you have installed multiple service controllers, reducing the receiver sensitivity of the service
controller from its maximum will help to reduce the amount of crosstalk between the wireless
stations to better support roaming clients. By reducing the receiver sensitivity, client stations will
be more likely to connect with the nearest access point.
transmit power
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
transmit power (DB | max)
Sets the maximum transmission power of the wireless radio.
Parameters
<db> Power is specified in steps of 1dBm. The maximum setting is 18 dBm.
Note: The actual transmit power used may less than the value specified. The service controller
determines the power to used based on the settings you made for regulatory domain, wireless
mode, and operating frequency.
multicast rate
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
multicast rate (1 | 2 | 5.5 | 6 | 9 | 11 | 12 | 18 | 24 | 36 | 48 | 54)
Sets the transmit rate for multicast traffic.
This is a fixed rate, which means that if a station is too far away to receive traffic at this rate, then
the multicast will not be seen by the station. By rasing the multicast rate you can increase overall
throughput significantly.
dot11 automatic frequency
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
dot11 automatic frequency
Enable this option to have the service controller automatically determine the best operating
frequency.
no dot11 automatic frequency
Disable automatic frequency selection.
dot11 automatic frequency period
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
dot11 automatic frequency period (disabled | 1h | 2h | 4h | 8h | 12h | 24h)
Specify how often the frequency setting is re-evaluated when automatic frequency selection is
enabled.
dot11 automatic frequency time
Supported on: MSM710 MSM730 MSM750 MSM760 MSM765zl
dot11 automatic frequency time <time>
Specify when the channel should be re-evaluated.
2-150
To Next Page
Loading...
Need help?
General
